Most moving-average systems use a line. The Ripster system uses an area. The space between the 34 and 50 EMA is wide enough to absorb normal noise and narrow enough to mark a real decision point.
What the one-sheet shows
The Ripster EMA Cloud System one-sheet above sums it up: when two EMAs such as the 5/12 or the 34/50 are plotted together, the area between them is shaded to form a cloud. If the cloud is green and price stays above it, the trend is bullish. If the cloud is red and price stays below it, the trend is bearish. A wide cloud shows strong momentum; a narrow or flipping cloud may signal a weakening trend.
Three readings of the same cloud
- Bias. Over the cloud, look for longs; under it, shorts. “Never short over the 10-min 34/50, never long under it.”
- Risk. “Whenever you long or short, that 34-50 EMA cloud is your risk level.” Your stop sits on the other side of the cloud, so the trade is wrong the moment the bias is wrong.
- Trend change. “Many a times a stock will change trend right on these clouds.” When price crosses and holds, a long becomes a short and a short becomes a long.
Turning the cloud into a position size
Once the stop is defined by the cloud, the size follows: shares = R ÷ (entry − stop). A tight cloud gives a larger size for the same risk; a wide cloud gives a smaller one. See Position Sizing with R.
Common mistakes
- Treating a wick through the cloud as a break. Wait for the 10-minute close.
- Entering far above the cloud. The further price is from the EMAs, the worse the risk reward.
- Ignoring the higher timeframe. Check the 1-hour 34-50 and the daily MTF Clouds before trusting a 10-minute signal.
Education only. Not a trade recommendation.
Related lessons
Education only, not financial advice. The chart is an educational example reviewed after the fact, not a trade recommendation.
